Disclaimer While every precaution has been taken in the preparation of this manual, Kenwood assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Kenwood reserves. • UHF FM TRANSCEIVER TK-880 SERVICE MANUAL REVISED EE3 version © 2000-10 PRINTED IN JAPAN B51-8524-10 ( N ) 569 This Service Manual was revised based on the service manual as per parts No. Arturia single pack the one crack cocaine.

B51-8524-00, in order to include new variants with the following destination codes: E3. • TK-880 GENERAL 3. PLANNING THE INSTALLATION INTRODUCTION 3-1. General SCOPE OF THIS MANUAL Inspect the vehicle and determine how and where the This manual is intended for use by experienced techni- radio antenna and accessories will be mounted. Cians familiar with similar types of commercial grade com- Plan cable runs for protection against pinching or crush- munications equipment. INSTALLATION PLANNING – CONTROL STATIONS 1.

Operation Features 4-1. Antenna system The TK-880 is a UHF FM radio designed in both 5-tone Control station.

Firmware Programming Mode TK-880 to be upgraded when new features are released in 1. Start up the programming software (Fpro. TK-880H Programming questions/issues - posted in Technical Discussion: Hello All, Recently, my brother and I both bought 2 TK-880H 40 watt radios on eBay. Most of the research I did prior to purchasing these indicated that you should be able to program these devices manually. However, both will not go into field programming mode, which is a bummer.

The antenna system selection depends model and DTMF/2-tone/DMS model. The programmable on many factors and is beyond the scope of this manual. • TK-880 OPERATING FEATURES 2-2. Programmable Keys Channel Name The FPU (KPG-60D) enables programmable keys to se- Press this key to switch between the 'Channel name' lect the following functions. And 'Grp #/Ch #' for the display.

If no channel name is pro. • TK-880 OPERATING FEATURES Group Up/Down Operator Selectable Tone When this key is pressed each time, the group number to When this key is pressed, the 'OST' appears and encode/ be selected is increased/decreased and repeats if held for decode QT/DQT is switched to the OST tone pair. If one second or longer. • TK-880 OPERATING FEATURES Receive Entry (5-tone) Selcall List Press [Receive entry] key to enter the desired Selcall Press [Selcall list] key to enter Selcall list mode. Code you want to receive.

This function can be activated • 5-tone only when 'RX address' is set to the channel and 'selectable receive digit'. • TK-880 OPERATING FEATURES Status Entry (5-tone) Function Table It allows the operator to input the status and transmit it to Function DTMF/2-tone/DMS 5-tone the base station.

None Both TX address and 'Selectable status digit' must be Auto dial programmed to perform the operation. Press [Status entry] Auto dial programming key to access Status entry mode. • TK-880 OPERATING FEATURES 2-3. Front Panel Displays and Indicators Handset indicator Sub display This icon is not used this transceiver.

Displays the system, channel and group numbers. Also MAIL indicator displays various functions, such as TA. Flashes when a status message (5-tone or DMS) is re- P (Priority) indicator ceived. • TK-880 OPERATING FEATURES Scan channel types Scan end 1) Priority channel is the most important channel for the When you reactivate the key programmed to the scan scan, and always detects a signal during scan and when function during scan mode, the scan ends. Joshua 5 13 6 27. • TK-880 OPERATING FEATURES Com port Radio password • Com 0 When the password is set in the transceiver, user can not use the transceiver unless enter the correct password.